PEL® T bushings

Manufactured from a thin wrapped steel strip, the PEL® T bearing has excellent resistance to wear and seizure and is suitable for high contact pressure and abrasive surroundings, in alternative or continuous rotation.

With these bearings the intervals of lubrication are increased.

This bushing exists in standard dimensions and could easily replace wrapped bronze bushing.

  Dyn. Load (N/mm²) Max speed (m/s) Max Temp (°C) Abrasion resistance Shocks resistance Corrosion resistance Low-Maintenance
PEL® T 100 8 250°C ++ ++ + ++

Downloads / Resources

Mating Shaft:

For optimal performances of the joint, the surface roughness should be inferior to Ra 0.8 μm and the hardness should be superior to 56 HRC. For optimal performances, special shafts are available from HEF DURFERRIT: PEL® ST, PEL® STC.

Advantages

Higher wear performance than:
- Rolled perforated bronze
- Loaded composite
- Sintered bronze polymer resin
- Bronze + graphite inserts

Applications

Glass industry
Earth moving equipment Agriculture
Handling